Canon REALIS SX80 MARK II - Manual (Page 23)

23
CHAPTER 3 • Appendix
Cause Solution
Items in "Discovery settings" are not
configured correctly Confirm the IP address of the projector, and •
configure the Discovery settings.
- If Projector is SNMP-compatible
Add a broadcast address of the network with the
projector in the "Broadcast" tab, or configure so
that the projector's IP address is included in the
"IP address ranges" tab of the "Discovery settings"
dialog (see pp. 5, 6, 7). In addition, "Protocol name
([SNMP V1]/[SNMP V2c]/[SNMP V3])", "Community
name" and "Password" must be configured to
match the network settings of the projector to allow
communication with the projector.
- If Projector is LV Series Compatible
Add an IP address of the projector in the "Discovery
settings" dialog (see p. 8).
Network settings of the projector and
protocol settings of this software are
different differently Configure the discovery settings or protocol settings •
of this software to match the SNMP settings of the
projector. This software cannot communicate with
the projector if SNMP version, community name
and password do not match.
Firewall for an administrative computer is
configured Although registration of this software in Windows •
Firewall is processed during installation, this
software may not be able to communicate with the
projector if other software such as an anti-virus
software is using firewall. Configure the software
such as an anti-virus software so that this software
can communicate with the projector. See the
instruction manual of the software for configuration
procedures.
Projector classified into "Warning" ■
Cause Solution
Projector is encountering trouble For projectors classified into "Warning" of the •
Projector group list, confirm its status with the
properties dialog. See the instruction manual that
came with the projector for malfunction details.
COP
Y