Canon REALIS SX80 MARK II - Manual (Page 21)

2C
CHAPTER 2 • Routine Operation
Setting the Protocol of a Projector 2.5.7
Projectors in the Projector list will display as "Disconnected" if network settings of projectors
are changed. In this case, adjust the protocol settings of the projector labelled "disconnected"
in accordance with the changed network settings, with the following procedures.
Select [Protocol settings] from the [Projector] menu.
1
"Protocol settings" dialog will appear.
Select a protocol from the [Protocol] pop-up menu, and adjust the settings.
2
Category Description
IP address Enter an IP address of the projector, in "XXX.XXX.XXX.
XXX" form.
Community name
(SNMP V1/V2c/V3 only) Enter a community name within 15 one-byte
alphanumerical characters and symbols.
Port number
(LV Series only) Enter a port number to be used, in one-byte numbers.
Default value is set to "7142".
Timeout Enter a number of seconds to time out, from 1 to 9.
Password
(SNMP V3 only) Enter a password within 8 to 15 one-byte alphanumeric
characters and symbols.
* Password is reset if protocol is changed.
Note
An error message will appear and settings will not be registered if a value -
of an entry is invalid or insufficient. Correct it as required.
Entries will be cancelled if [X] (Close) or [Cancel] button is clicked before
-
clicking the [OK] button.
Projectors may not connect immediately after its IP address is changed.
-
Refresh the projector status after a while.
Click [OK] when you have finished adjusting the settings.
3
Projector's protocol settings will be changed.
COP
Y