Canon LV 7490 - Manual (Page 29)

Basic Operation
29
Choose either COMPUTER 1 (ANALOG PC) or COMPUTER 2 (ANALOG PC) by pressing the
COMPUTER 1 or COMPUTER 2 button on the remote controller.
Before using these buttons, correct input source should be selected through Menu operation as
described below.
1
Input Menu
2
3
 Note:
When the Auto input function is set to On 1 or On
2 in the Auto setup function, the input signal will
be searched automatically (p.47).
COMPUTER 1
Remote controller
Press the MENU button to display the
On-Screen Menu. Use the Point ▲▼
buttons to select Input and then press the
Point ► button or the OK button.
Use the Point ▲▼ buttons to select
COMPUTER 1.
When COMPUTER 1 is selected, press
the Point ► button to access the submenu
items. Use the Point ▲▼ buttons to select
the ANALOG PC input source and then
press the OK button.
COMPUTER 1(SCART)
Input Source Selection (ANALOG PC: COMPUTER 1/COMPUTER 2)
COMPUTER 2 (ANALOG PC)
Direct Operation
Menu Operation
Computer Input
OR
Use the Point ▲▼ buttons to select
COMPUTER 2 and then press the OK
button.
COMPUTER 1 button
COMPUTER 2 button
COMPUTER 1 (ANALOG PC)
INPUT button
Top Control