Canon i-SENSYS MF4780w - Manual (Page 8)

8
En
8
Enter the network key.
1 Enter the network key using the numeric keys.
2 Select , and then press [OK].
WEP Key (5-26 Char.)
Entry Mode: A
9
Select , and then press [OK].
10
After the screen is displayed,
wait until the Wi-Fi indicator stops blinking and
turns on.
Wait approximately 2 minutes after the
connection.
IP address is set during this period of time.
When an error message appears:
Press [OK] to close the screen, check whether or not
the network key is correct, and then retry the settings.
If the access point cannot be detected even after
retrying, see the following.
e-Manual "Onscreen Messages"
To set IP address manually:
e-Manual "Setting the IPv4 Address"
Checking That the Wireless LAN Setting
is Completed
1
Press [ ] (Status Monitor/Cancel).
2
Select , and then press
[OK].
3
Select , and then press [OK].
4
Select , and then press [OK].
5
Take note of the IP address.
IP Address
192.168.0.215
6
Press [ ] (Status Monitor/Cancel).
7
Start a web browser from a computer, enter
"http:///" in the
address field, and then press [Enter] on your
keyboard.
8
Check that the screen of the Remote UI
isdisplayed.
Connection is completed if the screen is displayed.
When the screen is not displayed correctly:
e-Manual "Network Problems"