Brother DCP-J140W - Manual (Page 22)

22
For Wireless Network Users
12 One-push configuration
using WPS or AOSS™
(Windows
®
and
Macintosh)
a
Confirm your wireless access point/router has
the WPS or AOSS™ symbol as shown below.
b
Place the Brother machine within range of your
WPS or AOSS™ access point/router. The
range may differ depending on your
environment. Refer to the instructions provided
with your access point/router.
c
On your machine, press Menu.
Press a or b to choose 3.Network and press
OK.
Press a or b to choose 3.WPS/AOSS and press
OK.
When WLAN Enable? is displayed, press a to
accept.
This will start the wireless setup wizard.
d
When the LCD shows Press Key on rtr,
press the WPS or AOSS™ button on your
wireless access point/router. See the user’s
guide of your wireless access point/router for
instructions.
Then press a (Next) and your machine will
now automatically detect which mode (WPS or
AOSS™) your wireless access point/router
uses and try to connect to your wireless
network.
e
A connection result message appears for
60 seconds on the LCD and a wireless LAN
report will automatically be printed.
If the connection failed, check the error code on
the printed report and refer to Troubleshooting
on page 23.
Wireless setup is now complete.
To install MFL-Pro Suite, continue to
step 13.
For Windows
®
Users:
Now go to
Page 25
For Macintosh Users:
Now go to
Page 28
Note
If your wireless access point/router supports WPS
(PIN Method) and you want to configure your
machine using the PIN (Personal Identification
Number) Method, see Configuration using the
PIN Method of Wi-Fi Protected Setup in the
Network User’s Guide.