Brother DCP-J140W - Manual (Page 21)

21
For Wireless Network Users
Wirele
ss Network
12 Manual configuration
from the control panel
(Windows
®
and
Macintosh)
a
On your machine, press Menu.
Press a or b to choose 3.Network and press
OK.
Press a or b to choose 2.Setup Wizard and
press OK.
When WLAN Enable? is displayed, press a to
accept.
This will start the wireless setup wizard.
To cancel, press Stop/Exit.
b
The machine will search for available SSIDs. It
will take several seconds to display a list of
available SSIDs.
If a list of SSIDs is displayed, press a or b to
choose the SSID you wrote down in step
11-b
on page 17, then press OK.
If the wireless access point/router of the
selected SSID supports WPS and the machine
asks to use WPS, press a (Next) and go to
c.
If the machine asks you to enter a Network
Key, go to
d.
Otherwise, go to e.
c
Press a (Yes) to connect your machine using
WPS. (If you choose b (No) to continue manual
setting, go to
d to enter a Network Key.)
When the LCD shows Press WPS on rtr,
press the WPS button on your wireless access
point/router, and then press a (Next) to
proceed.
Go to
e.
d
Enter the Network Key you wrote down in
step
11-b on page 17 using the a, b keys to
choose each letter or number.
Use Enlarge/Reduce key or Number of
Copies key to move the cursor left or right.
For example, to enter the letter a, press the a
key once. To enter the number 3, hold down
the a key until it appears.
The letters appear in this order: lower case,
upper case, numbers and then special letters.
(For more information, see Entering Text for
Wireless Settings on page 31.)
Press OK when you have entered all the
characters, then press a (Yes) to apply your
settings.
e
Your machine will now try to connect to your
wireless network. It may take a few minutes.
f
A connection result message appears for
60 seconds on the LCD and a wireless LAN
report will automatically be printed.
If the connection failed, check the error code on
the printed report and refer to Troubleshooting
on page 23.
Wireless setup is now complete.
To install MFL-Pro Suite, continue to
step 13.
For Windows
®
Users:
Now go to
Page 25
For Macintosh Users:
Now go to
Page 28
You must have the wireless settings you
wrote down for your network in step
11-b on
page 17 before you proceed.
Note
• If a list of SSIDs is not displayed, make sure
your access point is on. Move your machine
closer to the access point and try starting
from
a again.
• If your access point is set to not broadcast the
SSID, you will have to manually add the SSID
name. For details, see the Network User’s
Guide.