Brother HL-5440D - Manual (Page 154)

148
Troubleshooting
6
Machine Information
6
Default settings
6
The machine has three levels of default settings; the default settings have been set at the factory before
shipment.
 Network (HL-5450DN only)
 Factory Reset
 Settings Reset
Note
• You cannot modify the preset default settings.
• Page counters can never be changed.
Network default settings (HL-5450DN only)
6
If you want to reset only the print server back to its default settings (by resetting all network information such
as the password and IP address), follow these steps:
a
Turn off the machine’s power switch.
b Make sure that the front cover is closed and the power cord is plugged in.
c Hold down Go as you turn on the power switch. Keep Go pressed down until all the LEDs light up and
then the Ready LED turns off.
d Release Go. Make sure that all the LEDs turn off.
e Press Go six times. Make sure that all the LEDs light up to indicate the print server has been reset to its
factory default settings. The machine will restart.
Factory Reset
6
You can partially reset the machine back to its default printer settings. The network settings will not be reset:
a
Turn off the machine’s power switch.
b Make sure that the front cover is closed and the power cord is plugged in.
c Hold down Go as you turn on the power switch. Keep Go pressed down until all the LEDs light up and
then the Ready LED turns off.
d Release Go. Make sure that all the LEDs turn off.
e Press Go eight times. Make sure that all the LEDs light up to indicate the machine has been reset to its
factory default settings (except the network settings). The machine will restart.