Brother HL 2270DW User Manual
Page 32
Control panel setup
28
5
Enabling or disabling the wireless network (For HL-2135W,
HL-2270DW and HL-2275DW)
5
If you want to switch the wireless network to enabled/disabled (disabled is the default), please follow these
steps:
a
Make sure that the power cord is plugged in.
b
Turn on the machine and wait until the machine is in the Ready state.
c
Hold down Go for 10 seconds. Release Go when the machine prints a Network Configuration page that
indicates the current network settings.
Note
If you release Go in less than 10 seconds, the machine will print if you have any reprint data.
d
Check the text to the right of IEEE 802.11b/g in the Node Type section. Active means that the wireless
setting is enabled and Inactive means that the wireless setting is disabled.
Note
You can switch the wireless network to enabled/disabled, using the BRAdmin applications or Web Based
Management (web browser). (For more information, see Other Management Utilities on page 6.)
Brother NC-XXXXw, IEEE 802.11b/g (Active)
Firmware Ver.0.20 (07.11.22)
XX-XX-XX-XX-XX-XX
BRWXXXXXXXXXXXX
BRNXXXXXXXXXXXX
BINARY_P1
TEXT_P1
POSTSCRIPT_P1
PCL_P1
BRNXXXXXXXXXXXX_AT