Brother HL 2270DW - Manual (Page 12)

12
Macintosh
Wired Network
For Wired Network Cable Users for Macintosh
(HL-2270DW and HL-2275DW only)
6
Before you install
a
Make sure your machine is plugged in and your
Macintosh is switched ON. You must be logged
on with Administrator rights.
b
Remove the protective cap from the LAN
connector.
c
Connect the network cable to the LAN
connector marked with a symbol and then
connect it to a free port on your hub.
d
Make sure the machine power switch is on.
7
Install the printer driver
a
Put the installation CD-ROM into your
CD-ROM drive.
b
Double-click the Start Here OSX icon. Follow
the on-screen instructions.
c
Follow the on-screen instructions until this
screen appears. Choose your machine from
the list, and then click OK.
IMPORTANT
• For the latest drivers and information on the
Mac OS X you are using, visit
http://solutions.brother.com/.
• For Mac OS X 10.4.0 to 10.4.10 users,
upgrade to Mac OS X 10.4.11 - 10.6.x.
Note
It may take a few minutes for installation to
complete.
Note
• If there is more than one of the same model
connected on your network, the MAC Address
(Ethernet Address) will be displayed after the
model name.
• You can find your machine’s MAC Address
(Ethernet Address) and IP Address by printing
out the Printer Settings Page. See Print the
Printer Settings Page on page 31.