Brother MFC-J630W - Manual (Page 74)

60
No Paper Fed The Photo Bypass Tray is in the Photo
printing position. Verify that the Photo Bypass Tray is in
the Normal printing position.
(See step d and the Important note in
Loading photo paper on page 13.)
The machine is out of paper or paper
is not properly loaded in the paper
tray. Do one of the following:
 Refill the paper in the paper tray,
and then press Black Start or
Color Start.
 Remove the paper and load it
again and then press Black Start
or Color Start. (See Loading
paper and other print media
on page 9.)
The paper is jammed in the machine. Remove the jammed paper by
following the steps in Printer jam or
paper jam on page 65.
The Jam Clear Cover is not closed
properly. Check the Jam Clear Cover is closed
evenly at both ends. (See Printer jam
or paper jam on page 65.)
No Response/Busy The number you dialed does not
answer or is busy. Verify the number and try again.
Not Registered You tried to access a Speed Dial
number that is not programmed. Set up the Speed Dial number. (See
Storing Speed Dial numbers
on page 41.)
Out of Fax Memory The fax memory is full. Do one of the following:
 Clear the data in the memory. To
gain extra memory, you can turn
off Memory Receive. (See Turning
off Memory Receive operations in
chapter 4 in the Advanced User’s
Guide.)
 Print the faxes that are in the
memory. (See Printing a fax from
the memory in chapter 4 in the
Advanced User’s Guide.)
Out of Memory The machine's memory is full. Copy operation in progress
Do one of the following:
 Press Stop/Exit and wait until the
other operations in progress finish
and then try again.
The memory card or USB Flash
memory drive you are using does not
have enough free space to scan the
document. Delete unused files from your memory
card or USB Flash memory drive to
make some free space and then try
again.
Error Message Cause Action