Brother MFC-J630W - Manual (Page 71)

Troubleshooting
57
B
Cannot Detect You installed a new ink cartridge too
quickly and the machine did not detect
it. Take out the new ink cartridge and
re-install it slowly until it clicks.
If you are not using Genuine Brother
Innobella™ ink the machine may not
detect the ink cartridge. Use a new Genuine Brother
Innobella™ Ink Cartridge. If the error
is not cleared, call Brother Customer
Service.
An ink cartridge is not installed
properly. Take out the new ink cartridge and
re
- install it slowly until it clicks. (See
Replacing the ink cartridges
on page 53.)
Cannot Print
Replace Ink
One or more of the ink cartridges have
reached the end of their life. The
machine will stop all print operations.
While memory is available, black and
white faxes will be stored in the
memory. If a sending machine has a
color fax, the machine's “handshake”
will ask that the fax be sent as black &
white. If the sending machine has the
ability to convert it, the color fax will be
stored in the memory as a black &
white fax. Replace the ink cartridges. (See
Replacing the ink cartridges
on page 53.)
Comm.Error Poor telephone line quality caused a
communication error. Send the fax again or connect the
machine to another telephone line. If
the problem continues, call the
telephone company and ask them to
check your telephone line.
Connection Fail You tried to poll a fax machine that is
not in Polled Waiting mode. Check the other fax machine's polling
setup.
Cover is Open The scanner cover is not completely
closed. Lift the scanner cover and then close it
again.
The ink cartridge cover is not
completely closed. Firmly close the ink cartridge cover
until it clicks.
Data Remaining Print data is left in the machine's
memory. Press Stop/Exit. The machine will
cancel the job and clear it from the
memory. Try to print again.
Disconnected The other person or other person's fax
machine stopped the call. Try to send or receive again.
Document Jam The document was not inserted or fed
properly, or the document scanned
from the ADF was too long. (See Using the ADF on page 22.)
(See Document jam on page 64.)
DR Mode in Use The machine is set to Distinctive Ring
mode. You cannot change the
Receive Mode from Manual to another
mode. Set Distinctive Ring to Off. (See
Turning off Distinctive Ring
on page 35.)
High Temperature The print head is too warm. Allow the machine to cool down.
Error Message Cause Action