Serial (rs-232c) mode, K $gydqfhg )xqfwlrqv, Hold down d and press 0 – Brother PT-9600 User Manual
Page 22: G ydq fhg )x qf wlr qv
17
&K $GYDQFHG )XQFWLRQV
$G
YDQ
FHG
)X
QF
WLR
QV
9 Select the desired baud rate, and then click
the Next button.
A dialog box confirming the settings
appears.
0 Check that the baud rate will be changed as
desired, and then click the Next button.
A dialog box appears, showing that the
baud rate has been changed as specified.
A Click the Finish button. A dialog box
appears, showing that installation is fin-
ished.
B Click the Finish button.
Serial (RS-232C) mode
After the PT-9600 is connected to a computer
using an RS-232C cable, the P-touch must be set
to Interface mode in order for it to be able to
communicate with the computer.
To enter/exit Interface mode
(RS-232C connection):
●
Hold down
d and press 0.
NOTE
Normally “9600 bps” is selected; however, your
computer may not be able to support a baud rate of
9600 bps. If this is the case, refer to the computer’s
instruction manual, and select the maximum possi-
ble baud rate.
NOTE
To change the settings, click the Back button, and
return to step
9
.
NOTE
If a dialog box appears, explaining that the com-
puter should be restarted, select the option for
restarting the computer, click the Finish button to
restart the computer, and then remove the CD-
ROM from the computer.
Length
Margin
Font
Width
Size
1
2
3
4
5
6
7
8
9
A
B
C
D
E
F
K
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
R
R
R
R
R
R
G
H
I
J
AUTO
1.10
HELSINKI
A
AUTO
INTERFACE
RS ONLINE