Brother PT-E500 - Manual (Page 52)

51
Error Messages
8
1
2
3
4
5
6
7

TROUB
L
ESHO
O
TI
NG
Insert HS 0.23"
Tube Cassette!
Insert HS 5.8mm
Tube Cassette!
A 0.23" (5.8 mm) Heat Shrink Tube is not installed when Template for
0.23" (5.8 mm) Heat Shrink Tube is selected. Install a 0.23" (5.8 mm)
Heat Shrink Tube.
Text Too Long! The length of the label to be printed using the text entered is longer
than the length setting. Edit the text to fit within the set length or
change the length setting.
Memory Full! There is not enough internal memory available when you try to save
a label file. Delete any unnecessary files to make more memory
available for the new label file.
Check # of Digits
Entered!
The number of digits entered in the bar code data does not match the
number of digits set in the bar code parameters. Enter the correct
number of digits.
Input A,B,C or D At
Start&End!
The bar code data entered does not have the required start/stop code
(A, B, C, or D required at the beginning and end of the bar code data
for the CODABAR protocol). Enter the bar code data correctly.
Maximum Of 5 Bar
Codes Per Label!
There are already five bar codes entered in the text data when you try
to enter a new bar code. You can only use up to five bar codes in each
label. You can enter up to two bar codes when is selected
in flag layout.
Text Too Large! The text size is too large. Select a different size option.
System Error 02! Please contact Brother customer service.
Refer to the Quick Setup Guide for the contact information.
Select Other Cut
Option!
The tape length set using the tape length setting is shorter than the
total length of the left and right margins applied for the "Large Margin"
cutting option. You have to select a different cutting option.
Close Cover! The rear cover is open. Close the cover when printing.
Installed tape is
not compatible
with this machine!
Tape that is incompatible with the P-touch labeling system has been
installed. Use a compatible tape.
Line Limit! Max
297 Lines per
Label
Exceeds max. You can enter up to 297 lines in the whole page and
blocks.
Block Function is
not Allowed!
In this setting, you cannot add or delete blocks.
Line Limit! Max 3
Lines
PUNCH-DOWN BLOCK layout allows to print up to 3 lines / block.
This Function
Requires 0.35" or
Wider Tape!
This Function
Requires 9mm or
Wider Tape!
PUNCH-DOWN BLOCK layout must use 9mm or wider tape
cassettes.
Sequence Type
Must be None
When Editing!
Texts cannot be edited when you set Sequence Type in PUNCH-
DOWN BLOCK to Horizontal or Backbone.
Message Cause/Remedy