Label outlet maintenance – Brother QL-500 User Manual
Page 53
53
STEP
1
STEP
2
STEP
3
For Win
dows
For M
acintosh
STEP
4
When the glue is attached on the label
outlet (metallic plate part and resin
guide part) and the printer chews up a
label, pull out the power plug from the
outlet and clean it up with cloth dipped
into ethanol or isopropyl alcohol.
It is recommended to clean the label
outlet when replacing the cutter unit.
4
Insert the edge (A) of cleaning sheet into the printing unit and pull it
out to just in front of the cutter.
•
Insert the sheet without removing the A part of sheet.
•
Check that the printing surface of cleaning sheet is upward.
5
After inserting the cleaning sheet into the
printing unit, push down the roll release lever
and remove the B part of cleaning sheet.
6
Close the DK Roll cover and turn ON the power of the printer.
7
Press the Feed button for more than one
second.
The roller spins by 4" (10 cm).
The adhesive face of cleaning sheet removes the stain
or dust on the roller.
•
If not pressing the Feed button for more than one
second, the roller spins only 1/3" (8 mm).
•
Dispose the cleaning sheet after use.
Feed button
Label outlet maintenance
Label outlet