Brother 4234D - Manual (Page 9)

5
English
Trim trap
The optional trim trap holds the trimmed
fabric and thread produced when sewing.
To install:
Insert the trim trap until it contacts the front cover.
NOTE:
Be sure to position the positioning guide to the one
on the machine.
To remove:
Slowly pull out the trim trap.
NOTE:
The optional trim trap can also be used as the foot
controller holder.
CAUTION
Always remove the foot controller from the trim
trap when carrying the machine.
Free-arm sewing (removing bed extension)
Free-arm sewing enables tubular pieces to be sewn
more easily.
1. Remove the bed extension .
NOTE:
Be careful not to lose the removed bed extension.
2. Position the fabric, and start sewing. (See CHAPTER
5.)
Wide table
Using the wide table makes the large piece sewing
easy.
To install:
Attach the wide table by pushing it in the direction
of the arrow until the edge line
1 is aligned to the line
2 of the bed extension .
2
1
To remove:
To remove the wide table , lift up the machine a little
and then pull out the wide table in the direction of
the arrow.
NOTE:
Do not move the machine while the wide table is
attached, otherwise damage or injuries may occur.