beautypg.com

Brother 4234D User Manual

Page 22

background image

18

Threading the needle

(using the needle threader)

The needle can be threaded by one-touch

operation using the needle threader.

1. Lower the presser foot lever 1 to lower the

presser foot.

1

2. Pull the end of the thread, which has been

passed through the needle bar thread guide
2

, to the left, then pass the thread through the

notch of the thread guide 3, and then firmly

pull the thread from the front and insert it into

the slit of the thread guide disk 4 all the way.

NOTE:

Make sure that the thread passes the notch of the

thread guide

3

.

2

3

4

3. Cut the thread with the thread cutter 5 on the

left side of the machine.

5

4. Lower the needle threader lever 6 on the left

side of the machine as much as possible.

6

The thread passes through the eye of the

needle.

5. Release the needle threader lever 6.

6. Carefully pull the loop of the thread through the

eye of the needle to pull out the end of the

thread.

7. Raise the presser foot lever 1, then pass the

end of the thread through the presser foot, and

then pull out about 5 cm (2 inches) of thread

toward the rear of the machine.

5cm

This manual is related to the following products: