Brother PJ-623 - Manual (Page 10)

１ -５ Command details
1. Paper feed commands
CR
[ N a m e ] Carriage return
[ C o d e ] 0Dh
[Function] Returns the cursor position to the left edge.
[Details] If automatic line feed has been specified with the utility, a line feed command
(LF) is performed after a carriage return command (CR) is performed.
FF
[ N a m e ] Form feed
[ C o d e ] 0Ch
[Function] Feeds the paper to the next page separation.
[Details] At this time, the SO and ESC SO commands are cancelled.
The feed specifications depend on the specified feed mode.
LF
[ N a m e ] Line feed
[ C o d e ] 0Ah
[Function] Feeds the paper by one line, according to the specified line feed amount.
[Details] At this time, the SO and ESC SO commands are cancelled.
ESC 0
[ N a m e ] Specify line feed of 1/8 inch
[ C o d e ] 1Bh
30h
[Function] Specifies a line feed of 1/8 inch (about 0.32 cm).
ESC 2
[ N a m e ] Specify line feed of 1/6 inch
[ C o d e ] 1Bh
32h
[Function] Specifies a line feed of 1/6 inch (about 0.42 cm).
[Details] The default line feed setting is 1/6 inch.
ESC 3 n
[ N a m e ] Specify line feed of n/180 inch
[ C o d e ] 1Bh
33h nnh
[Function] Specifies a line feed of n/180 inch.
ESC A n
[ N a m e ] Specify line feed of n/60 inch
[ C o d e ] 1Bh
41h nnh
[Function] Specifies a line feed of n/60 inch.
[Details] The allowable setting range is 0≤n≤85 (55h).
ESC + n
[ N a m e ] Specify line feed of n/360 inch
[ C o d e ] 1Bh 2Bh nnh
[Function] Specifies a line feed of n/360 inch.
©Copyright 2011 BROTHER INDUSTRIES, LTD.
10