State GTS-240-NIH - Manual (Page 10)

10
Page
Installation
Installation Manual
The pipe cover protects the plumbing pipes to
the water heater from unexpected adjustments.
This pipe cover is fixed to the bottom of the water
heater, which hides the plumbing and improves
the visual aspects of the whole installation for the
water heater.
The temperature remote controller has two
functions. It allows the output temperature
from the water heater to be adjusted within the
range of 100 °F to 185 °F, and it also works as a
diagnostic tool that will give a concise error code
whenever there is a problem with the unit. The
temperature options are 100 °F, 105 °F, 110 °F,
115 °F, 120 °F, 125 °F, 130 °F, 135 °F, 140 °F, 145
°F, 150 °F, 155 °F, 160 °F 165 °F, 175 °F and 185 °F.
See the Troubleshooting Section for information
on possible error codes.
1. Temperature remote controller:
9008172005 (TM-RE40)
3. Pipe cover: 9008331005 (TH-PC03) 4. Neutralizer kit: 9007607005 (TH-NT01)
The neutralizer assembly
neutralizes the condensate
(acidic water) that forms in the
secondary heat exchanger of the
water heater.
It connects to the condensate
drain port of the water heater by
using connectors included with
the neutralizer kit. Refer to p. 27
for the details.
6. 3" PVC concentric termination: 9007611005 (TH-CVPVC33)
Used when terminating direct-vent (sealed combustion)
systems, with Indoor models that require a 3 in. (76 mm)
intake and a 3 in. (76 mm) exhaust. This concentric
termination provides the convenience of only having to
make one penetration through a sidewall instead of two
separate penetrations for the intake and exhaust piping. The
termination includes a bird screen, restricting small animals,
pests, and foreign objects from entering into the vent system.
2. 4” Backflow preventer and F-F adaptor:
9007996005
There are two functions available for this
adaptor, which can be connected with the water
heater and NovaVent venting line and prevents
the backflow of air through the exhaust vent.
This helps prevent harmful exhaust gases from
entering the home, as well as helping to prevent
the unit from freezing in areas where cold air
can be blown or drawn into the exhaust system.
Install this adaptor in accordance with the
installation instructions that are packaged with
the adaptor and any applicable codes.
5. Sidewall vent terminator (Hood) and Wall thimble:
They are used when venting out through the wall. These terminations are special stainless steel
vents for gas appliances and are UL listed as Category II, III and IV. For different wall thicknesses,
there are two ranges of lengths available. (Refer to the NovaVent brochure for details.) Install these
vent terminations in accordance with their installation instructions and any applicable local codes.
Covering wall thicknesses Part#
Terminator Hood 9007999005
Wall Thimble 4 - 7 in. 9008345005
Wall Thimble 5 - 10 in. 9008346005
Termination + Thimble 4 - 7 in. 9008004005
Termination + Thimble 5 - 10 in. 9008005005
Wall Thimble Terminator Hood