ROTRONIC CF8-W-Disp-CO - Manual (Page 11)

Dokument
UMA 147 Rev
1 Page
11 (16)
4.
Push ENTR(+-) once. The display shows EC and two digits. Enter the access
code to the service menu. If the default code is used do like this: Push
MENU(+) until the digits stop. The display shows EC55. If the correct code is
not entered before the time limit exceeds the sensor returns to DEFAULT.
5.
Push ENTR(+-) once. The display shows SPCO to set the carbon monoxide
set point.
6. Push ENTR(+-) once. The display shows the carbon monoxide set point e.g.
ex 35 ppm. Push MENU(+) to increase the set point value in steps of 1 ppm.
Push ESC(-) to decrease the set point value in steps of 1 ppm.
7.
Push ENTR(+-) once when the set point is set. The display shows SPCO.
Push ESC(-) to return to DEFAULT.
8.
Push MENU(+) once to reach the carbon dioxide set point.
The display shows SP C.
9.
Push ENTR(+-) once. The display shows the carbon dioxide set point e.g. 750
ppm. Push MENU(+) to increase the set point value in steps of 50 ppm.
Push ESC(-) to decrease the set point value in steps of 50 ppm.
10.
Push ENTR(+-) once when the set point is set. The display shows SP C.
Push ESC(-) to return to DEFAULT.
11.
Push MENU(+) once to reach the setting of analogue outputs.
The display shows AOUt.
12.
Push ENTR(+-) to reach the output to be set. The display shows An and two
digits e.g. An 01. Step to the requested output by pushing MENU(+).
13.
Push ENTR(+-) to reach the setting of the MIN value. The display shows Set
L.
14. Push ENTR(+-) to set the MIN value of the output. The display shows the
numerical value in % e.g. the standard setting 0.0 % or previously set value.
Push MENU(+) to increase the MIN value. Push ESC(-) to decrease the MIN
value. Push ENTR(+-). The display shows Sure. Push ENTR(+-) to save the
setting and return to Set L. Push MENU(+) or ESC(-) to return to Set L without
saving the new setting.
15. Push MENU(+) to reach the setting of the MAX value. The display shows Set
H.
16. Push ENTR(+-) to set the MAX value of the output. The display shows the
numerical value in % e.g. the standard setting 100.0 % or previously set value.
Push MENU(+) to increase the MAX value. Push ESC(-) to decrease the MAX
value. Push ENTR(+-). The display shows Sure. Push ENTR(+-) to save the