PNI CommBoard - Manual (Page 19)

PNI Sensor Corporation DOC#1018122 r02
PNI CommBoard User Manual Page 17
Example #2: $0.wnaa,03,03,05,06,08,00$1
This sentence establishes which data components are to be reported by a V2Xe. In
this case, 3 components are to be reported: heading, magnitude, and distortion. After
writing this, the SSN line is set HIGH.
Example #3: $0.wnaa,04,00$1.....$0rLLN$1
This sentence can be used to obtain measurement data from a V2Xe. Again, note the
pause commands, in this case 5x2 ms or 10 ms total prior to reading the data. The
word lengths in the read command are set to accommodate reporting of the heading,
magnitude, and distortion, as established in the prior command.