PNI CommBoard User Manual
Page 10
PNI Sensor Corporation
DOC#1018122 r02
PNI CommBoard User Manual
Page 8
Plug your PNI device into the CommBoard. Pin 1 of the device should plug into pin 1 on the
CommBoard. For the SpacePoint Scout and V2Xe, this means the arrow printed on the
device will point towards the CommBoard‟s mini-USB connector, while for the RM3100 and
RM3000-f Evaluation Boards the arrow will point away from the mini-USB connector.
Finally connect the CommBoard to your computer using a USB-to-mini-USB cable. The red
and blue LEDs on the CommBoard should light up. Press the Reset button (SW1) on the
CommBoard to ensure the computer is correctly interpreting your device‟s communication
protocol