Nordisc, Adjustable speed drives – NORD Drivesystems U21010 User Manual
Page 4

Removal and re-assembloy of motor or C-face input adapter
(Flex-C-Input)
A. Separate the driven disc assembly from the driving disc
assembly and remove the driving disc (See Separate
Instructions).
B. After removing the driving disc (Item 489), the mounting
bolts for the motor or C-Face adapter can be accessed.
To gain access to all four bolts requires the removal of
the two cam grooves (Item 477). The cam grooves can
be removed by fi rst removing the socket head screws
(Item 478). Then, the motor or adapter bolts ((Item 453)
can be removed.
C. Assembly is the reverse of disassembly.
MOTOR / C-FACE ADAPTER
462
465
472 (474)
477
478
MOTOR BOLTS (4X)
479
IMPORTANT NOTE
The cam grooves or tapered gibs (Item 477) need to be
adjusted during assembly.
Cam groove or tapered gib adjustment
The cam groove or tapered gib on the right side (Item 477)
is not adjustable. The cam groove on the left-hand side
is to be adjusted by the screws (Item 479) located next to
the slide bar (Item 477). The cam grooves are properly ad-
justed when the slide plate (Item 472 or 474) is allowed to
move freely through its complete range.
A. Remove the handwheel assembly nut (Item 465) and
handwheel (Item 462) before making adjustment.
B. Clean sliding surfaces of the slide plate and cam grooves,
and then re-apply a molybdenum-based anti-seize com
pound to these surfaces.
C. Assemble the motor and/or c-face adapter to the slide-
plate (Item 472/474) by re-installing the motor bolts.
Apply a thread-locking agent to the screw threads
during
assembly.
D. Place the non-adjustable (right-side) cam groove onto
the slide plate and tighten the socket head setscrews
(Item 478). Apply a thread-locking agent to the screw
threads during assembly
E. Place the intermediate housing (Item 447) onto the
slide plate (Item 472 or 474) and then install the adjust-
able (Left-side) cam groove (Item 477).
F. Install the socket head screws (Item 478) and the adjust-
ment setscrews (Item 479). Apply a thread-locking
agent to the screw threads during assembly. Do not
completely tighten either set of screws – follow Steps 7
&
8!
G. Adjust the cam groove set screws (Item 479) so that
there is minimal side-play or side-movement and be
certain that the friction drive housing (Item 447) can
move
freely.
H. Then, tighten the socket head setscrews (Item 478).
I. After completing the adjustment of the cam grooves
(Item 477) the handwheel (Item 462) and handwheel
assembly nut (Item 465) can be re-installed.
J. Re-assemble the driving disc and re-connect the driving
disc assembly and the driven disc assembly.
DRIVESYSTEMS
NORDISC
™
ADJUSTABLE SPEED DRIVES
RETAIN FOR FUTURE USE
U21010 - 4 of 6
www.nord.com/docs
06.09.09
NORD Gear Corporation
Toll Free in the United States: 888.314.6673
NORD Gear Limited
Toll Free in Canada: 800.668.4378