Milestone Basis+ 6.5 - Manual (Page 11)

If the device is located behind a NAT-enabled router or
a firewall, the port(s) used can be changed by clicking
the Port Setup button. Remember to configure the
router/firewall to map these ports to the ports and IP
address used by the device.
When ready, click Next.
3. If a password is used for the device, type the password
for the device’s administrator account (called the
“admin” or “root” account on some devices). Leave the
Autodetect Device option selected, then click Next.
If you are in doubt about which administrator account
to use for a device, look in the Device Pack Release
Notes, available from the Downloads section of the
Milestone website, www.milestonesys.com.
4. When the device is detected, type the Device License
Key (DLK) for the device (if you imported the DLKs, the
field is pre-filled with the correct DLK). Then click Next.
5. Specify a descriptive name for the device, then click
Finish.
6. The device will now be listed in the Administrator
application’s Device Manager section. To view a list of
cameras attached to the device, click the plus sign
next to the device name.
Cameras are listed for each device with default names,
such as Camera 1, etc. If you want to change the
name of a camera, right-click the camera name in
question, then select Edit from the menu that appears.
10