Dwyer RSM - Manual (Page 7)

11.0 AGENCY ELECTRICAL STANDARDS
This device falls into CSA “Pollution Degree 2” for PCB insulation and CSA
˝Installation Category 2˝.
The RSM meets the following requirements:
CSA Standard C22.2 No 0-M 91: General Requirements - Canadian
electrical code, Part 1
CAN/CSA C22.2 No. 0.4-04: Bonding of Electrical Equipment
CAN/CSA-C22.2 No. 61010-1-04: Safety requirements for electrical
equipment for measurement, control and laboratory Use Part-1: General
Requirements
ANSI/UL61010-1 (Second Edition): Safety requirements for electrical
equipment for measurement, control and laboratory use Part 1: General
Requirements.
12.0 MAINTENANCE
The RSM is designed to operate in an indoor environment, monitoring
clean, dry air. Upon final installation of the RSM Room Status Monitor, no
routine maintenance is required. A periodic check of system calibration is
recommended. The RSM is not field serviceable and should be returned if
repair is needed (field repair should not be attempted and may void
warranty). Be sure to include a brief description of the problem plus any
relevant application notes. Contact customer service to receive a return
goods authorization number before shipping.
13.0 LOCATION OF COMPONENTS AND ACCESSORIES
P-3-RSM:TEMPLATE 2/17/11 2:22 PM Page 7