Crystal ConFigM30 Digital Pressure Calibrator Software - Manual (Page 8)

Settings  6
ConfigM30 User's Manual
Change Engineering Units dialog
•
Add a Unit: Select the unit to add and click the Add>> button . The unit will be moved from
the Available Units list to the Units in Gauge list.
•
Remove a Unit: Select the unit to remove and click the << Remove button . The unit will be
moved from the Units in Gauge list to the Available Units list.
•
Change the order of units: Select a unit in the Units in Gauge list and click the Move Up or
Move Down button .
•
Create a New Unit: Start with a blank unit by clicking New or by copying an existing unit
(select an existing unit and clicking Copy ). You can also edit an existing unit by clicking Edit .
Standard units such as PSI and kPa cannot be edited.
•
Delete a Custom Unit: Select the unit and click Delete . Standard units such as PSI and kPa
cannot be deleted.
X Creating a New Unit
Once in edit mode, set the unit abbreviation, PSI conversion factor, and resolution as appropriate. The icon for the unit is defined as a grid of squares. Use the
mouse to turn on and off the squares to create the icon that will be displayed.
Look at other pre-defined icons (such as PSI or kPa) for ideas on how to create new ones. Unit abbreviations and icons must be unique. Once finished defining
the unit, click the
Save button to save your changes.
Once all changes have been completed, click the Close button to close the dialog.
To discard any changes to the units in the gauge, click the Cancel button and no changes will be saved.
Note: Edits, additions, and deletions to custom engineering units cannot be undone.