Select meter size, Select display function, Select units of measure – Badger Meter B2800 User Manual

Page 8: Select rate (time) interval

Programming

Keys

Mode

Indicator

Units Display

And

Programming Choices

Rate / Total Display

And

Programming Choices

RUN PROGRAM
RELAY1 RELAY2

Figure 2: B2800 flow monitor

Select Meter Size

At the METER prompt, press ENTER The current meter size number will begin to flash Using the arrow keys, scroll through the

size choices to select the bore size of your meter Press ENTER to save meter size choice

OTEE:

The meter connection size and the bore size are different For example, many of the one inch NPT turbines have bore

sizes that range from 3⁄8 inch up to 1 inch Be sure to use the correct bore size or the meter will report incorrect flows

and totals

Select Display Function

The monitor can display RATE or TOTAL or alternate between BOTH rate and total At the DISPLAY prompt, press ENTER once

The monitor now shows the display mode currently in effect To change to an alternate display mode, use the arrow keys to

scroll to the desired display mode and press ENTER to save the choice

Select Units of Measure

The monitor allows the choice of many common rate units (See

for a complete listing of the

unit choices ) At the RATE UNT prompt, press ENTER The monitor now shows the current rate unit If the current selection

is correct, press ENTER to advance to the next parameter To change to an alternate unit, use the arrow keys to scroll to the

desired rate unit and press ENTER to save the choice

Select Rate (Time) Interval

The term rate implies that something is occurring over a period of time Most people are familiar with the rate of speed of a

car reported in miles per hour (mph) The same concept holds true for a flow meter The time choices are SEC (seconds), MIN

(minutes), HOUR (hours), and DAY (days) At the RATE INT prompt, press ENTER The monitor now shows the current time

interval If the current selection is correct, press ENTER to advance to the next parameter To change to an alternate time

interval, use the arrow keys to scroll to the desired time interval and press ENTER to save the choice

OTEE:

If flow rate is the only measurement of interest, skip to KFAC UNT to complete the programming process

Flow Monitor, B2800 Flow Monitor – Advanced

Page 8

November 2013