Badger Meter ORION AMR/AMI Hardware Solutions for Gas Utilities - Manual (Page 20)

1 Crimp the splices carefully and completely Use a parallel jaw crimper, such as a Badger Meter PN: 59983-001
NOTE: N For installation instructions see the Model GAS RT Installation Data sheet
2 If the gel-cap connections are made at the gas RT unit, carefully tuck the wires and gel caps under the plastic gas RT
cover Snap the cover back into place
3 If the gel-cap connections are made at the ORION remote endpoint, tuck the wires and splices up into the
ORION bottom
4 Place a strain relief onto one corner of the endpoint
Gas RT
Gel Caps
Snap Cover
Into Place
Gel-Cap Connections
Strain Relief
Gel-Cap Connections
ORION® Gas Endpoints, Remote Endpoint for Gas Meters and Volume Correctors with Pulsed Outputs
Page 20 July 2013