Mounting an orion remote endpoint to a pipe, Mounting an orion remote endpoint to a pipe 13 – Badger Meter ORION AMR/AMI Hardware Solutions for Gas Utilities User Manual
Page 13
MOUNTING AN ORION REMOTE ENDPOINT TO A PIPE
Insert the clamp through the appropriate slots on the rear of the ORION endpoint
It may be necessary to remove the endpoint from the housing to accomplish this Refer to
“ENDPOINT DISASSEMBLY” on page 10
The clamp fits a pipe up to 3 inches in diameter
A stainless steel clamp is recommended if a larger clamp is needed
Installation Manual
Page 13
July 2013
This manual is related to the following products: