Badger Meter Recordall Transmitter Register (RTR) - Manual (Page 7)

Installation Manual
CONNECTING THE OUTPUT 308 IN-LINE CONNECTOR TO AN ENDPOINT
Connector cables are labeled "OR/GA" to indicate compatibility with an ORION or GALAXY endpoint, or "ITRON" for an Itron
in-line connector. To connect an endpoint to the appropriate cable, see "Connecting the Input 308 In-line Connector to an RTR"
on page 5 .
OTEE: N Anytime a connector is used (308 or Itron in-line connector), program the endpoint to clear the tamper and enter the
correct reading from the register (into the endpoint) after all connections have been made. Refer to the appropriate
handheld or mobile user manual for programming instructions.
For a flying lead, a 308 connector harness can be purchased for connection to the connector cables labeled "OR/GA."
Refer to the appropriate endpoint installation data sheet if wiring an endpoint to the flying lead of a 308 harness.
DISASSEMBLING A 308 IN-LINE CONNECTOR
To disassemble a 308 in-line connector assembly, follow these steps:
1. Using a flat blade screwdriver, pry open the anti-tamper collar. Discard the anti-tamper collar, as it can be used
only once.
Figure 5: Use screwdriver to pry open anti-tamper collar
2. Squeeze the connector on the two ribbed sides and pull apart. The connector assembly disengages with
minimal force.
Page 7 August 2014