West Control Solutions TB 40-1 Temperature Monitor - Manual (Page 15)

Name Value range Description Default
20 Pt100 (-200.0 ... 100,0 °C)
21 Pt100 (-200.0 ... 850,0 °C)
22 Pt1000 (-200.0 ... 850.0 °C)
23 special 0...4500 Ohm (preset to KTY11-6 )
24 special 0...450 Ohm
30 0...20mA / 4...20mA 1
40 0...10V / 2...10V 1
S.Lin
Linearization (only at S.tYP = 23 (KTY 11-6), 24
(0...450
W
), 30 (0..20mA), 40 (0..10V) and 41 (0...100mV) )
0
0 none
1 Linearization to specification. Creation of linearization table
with engineering tool possible. The characteristic for KTY
11-6 temperature sensors is preset.
Corr
Measured value correction / scaling 0
0 Without scaling
1 Offset correction (at CAL level)
2 2-point correction (at CAL level)
3 Scaling (at PArA level)
1 with current and voltage input signals, scaling is required
(see chapter 5.3)
Out.1
Name Value range Description Default
O.Act
Method of operation OUT1 0
0 direct / normally open
1 inverse / normally closed
Out.2
Name Value range Description Default
O.Act Method of operation OUT2 0
0 direct / normally open
1 inverse / normally closed
LOGI
Name Value range Description Default
Err.r
Reset of all limit alarms 6
2 DI1
6 RESET- key
Configuration level
TB40-1 15 Configuration