Warren Controls E030 Electric Actuator - Manual (Page 2)

2 2600 Emrick Blvd • Bethlehem, PA 18020 • USA • 800-922-0085 • www.warrencontrols.com
ELECTRIC ACTUATOR SPECIFICATIONS*
Valve Usage: E024, E025 [Valve sizes 1/2 to 4 Inch]
E026 [Valve sizes 1 to 6 Inch]
E029, E030 [Valve sizes 1-1/4 to 10 Inch]
______________________________________________________________________________________________
Power supply:
24 VAC ± 20% 50/60 Hz, 24 VDC ± 10%
______________________________________________________________________________________________
Power Consumption:
E024 6 VA
E025, E026 21 VA
E029 10 VA
E030 50 VA (Actuator 10VA, VMS-35 40VA)
______________________________________________________________________________________________
Timing:
90 seconds full stroke max
______________________________________________________________________________________________
Control Signal:
2-10 Vdc (default), 4-20 mAdc [with KR500 (resistor kit)]
______________________________________________________________________________________________
Feedback Signal:
2-10 Vdc
______________________________________________________________________________________________
Signal Failure Direction: E024, E029
Fail Closed or Lower Port Closed (default), or
Fail Open or Upper Port Closed
E030 Fail-Safe (this choice dictates Power Failure Mode)
E025, E026 Fail Closed or Lower Port Closed (default), or
Fail Open or Upper Port Closed
______________________________________________________________________________________________
Power Failure Mode:
E024, E029 Fail-In-Place
E030 Fail-Safe
E025, E026 Fail Closed or Lower Port Closed (default), or
Fail Open or Upper Port Closed
______________________________________________________________________________________________
Capacitor:
E025, E026 Capacitor charge time 5 to 20 seconds
______________________________________________________________________________________________
Manual Override:
Yes, with supplied Allen Key (4mm E024, E025 / 5mm, E026, E029, E030)
______________________________________________________________________________________________
Construction:
Aluminum die cast Yoke, plastic Housing
______________________________________________________________________________________________
Connections:
3 foot long 4 Conductor 18 gauge wire, pigtail (may include fifth pink colored conduc-
tor only used for factory programming. Do Not Use or Connect)
______________________________________________________________________________________________
Enclosure Type:
NEMA 2, IP54, UL 2
______________________________________________________________________________________________
Noise Level:
E024, E025 45 dBA
E026 60 dBA
E029, E030 65 dBA
______________________________________________________________________________________________
Environmental:
Operating: Ambient + 32°F to +122°F (0 to +50°C)
Humidity: 5 to 95% RH non-condensing
Storage: -40°F to +176°F [-40°C to +80°C]
______________________________________________________________________________________________
Orientation:
Factory Aligned per drawings
* See page 5 for VMS-35 Specifications