Hardware setup – Asus INTEL CUW(E)-FX User Manual
Page 35
35
3. HARDWARE SETUP
Connectors
3. H/W SETUP
ASUS CUW(E)-FX User’s Manual
16) Serial and Consumer IR Connectors (10-pin IR_CON)
This connector supports an optional wireless transmitting and receiving infra-
red module. This module mounts to a small opening on system cases that sup-
port this feature. You must also configure the setting through UART2 Use In-
frared (see 4.4.2 I/O Device Configuration) to select whether UART2 is di-
rected for use with COM2 or IrDA. Use the five pins as shown in Back View
and connect a ribbon cable from the module to the motherboard’s SIR connector
according to the pin definitions. An optional consumer infrared (CIR) set con-
nects to the CIR and SIR connectors simultaneously for both wireless transmit-
ting and remote control functions through one external infrared module. Wake
On PS2 KB/Mouse in 4.5.1 Power Up Control must be Enabled in order to use
Consumer Infrared (CIR) power up.
®
CUW(E)-FX
CUW(E)-FX Infrared Module Connector
Standard Infrared (SIR)
Front View
Back View
+5V
IRTX
IRRX
(NC)
GND
SIR
+5V
IRRX
IRTX
(NC)
GND
(NC)
GND
CIRRX
CIR+5V
CIR
IR_CON
17) Serial COM 2 Port Header (10-1 pin COM2)
The optional serial port bracket can be used to add a serial port for additional
serial devices.
®
CUW(E)-FX
CUW(E)-FX Serial Port Header
Pin 1
COM2