Thermo Fisher Scientific CyberScan PD 300 - Manual (Page 40)

Instruction Manual PD 300
P3.3 Selecting
°C or °F
This meter lets you select between °C and °F units for
temperature readings.
From measurement mode
1. Press the
MODE
key to select pH measurement
mode.
2. Press SETUP key to enter Set Up mode.
3. Press the ▲ or ▼ keys to scroll through
subgroups until you view parameter P3.0.
4. Press the ENTER key three times to select
parameter 3.3.
5. Press the ▲ or ▼ keys to toggle between °C and
°F.
6. Press the ENTER key to confirm selection and to
return to the subgroup menu. Press the
CAL/MEAS key to return to measurement mode.
Figure 26 – P3.3: Select
temperature units
See Figure on right.
NOTE
You can switch between °C and °F in Program P5.2 of % saturation mode (or P4.3 in mg/L
mode). If you switch between °C and °F in pH mode, the meter will also switch in % saturation
or mg/L mode.
35