Thermo Fisher Scientific CyberScan PD 300 - Manual (Page 27)

Instruction Manual PD 300
Taking measurements with READY ON indicator selected on
If the READY indicator has been activated, the READY annunciator lights when the reading is
stable.
To switch the READY indicator on or off in the SETUP program – see Section 8.10.1 on page
45 for directions.
Taking measurements with READY HOLD indicator selected on
Figure 18 – Auto endpoint
feature
When a reading is stable for more than 5 seconds, the
auto endpoint feature will automatically “HOLD” the
reading. The “HOLD” indicator appears on the left side of
the display. Press the HOLD key to release the reading.
To switch the Auto endpoint feature on or off in the
SETUP program – see Section 8.10.1 on page 45 for
directions.
(The values shown here are for illustration purpose. Your meter may display
different values depending on the settings & your environmental conditions)
22