Installation – Techne Hybrigene User Manual
Page 19
19
INSTALLATION
See also the sections on Safety and Installation.
1. Place the unit on a suitable flat bench or in a fume cupboard if required, ensuring that the air inlet
and outlet vents are free from obstruction.
2. Place some water in a hybridisation tube and fit the tube in the Hybrigene.
Adjust the feet on the
base of the unit by unscrewing them anticlockwise slightly until the unit is level. Check the level by
placing the tube in different positions in the oven.
3. Plug the mains cable into the power socket on the rear of the unit.
Rear view of the Hybrigene
FITTING STACKING PLATES AND WALL MOUNTING PLATES
A trained technician should carry out this work only after reading the full instructions.
There are two kits available for stacking and wall fixing either two or three Hybrigene units: