Cable connection, Mode selection – SHIMPO DT-311J-230V User Manual
Page 5
(3) Power switch
(4) Connector
(5) Mode select switch
(6) Setting knob: for Flash Rate and Phase Shift adjustment
(7) Zero setting switch
(8) Divide ratio select switch
(9) Stroboscope flash: on/off switch
(10) Shift switch
4. CABLE CONNECTION
Connect power and signal with provided cable as follows:
AC plug (with 3-prong plug)
110 VAC or 230VAC at 50/60 Hz
Red clip
Signal (positive)
Black clip
0V
5. MODE SELECTION
Press (MODE) switch (5) to select internal or external signal mode.
This manual is related to the following products:
See also other documents in the category SHIMPO Tools:
- DT-361 (36 pages)
- DT-365E (28 pages)
- DT-311A (4 pages)
- DT-315AEB (4 pages)
- DT-315P (17 pages)
- DT-326 (35 pages)
- DT-725 (4 pages)
- DT-900 (33 pages)
- ST-1000 (2 pages)
- ST-5000 (4 pages)
- SG-300 (2 pages)
- DT-721 (4 pages)
- DT-329 (32 pages)
- DT-105A (2 pages)
- DT-107A (2 pages)
- MT-100 (4 pages)
- MT-200 (4 pages)
- PT-110 (2 pages)
- DT-105A-S12 (2 pages)
- DT-205L (4 pages)
- DT-205L-S12 (4 pages)
- DT-207L (4 pages)
- DT-207L-S12 (4 pages)
- DT-209X (68 pages)
- DT-5TXR (20 pages)
- DT-5RL-1 (2 pages)
- DT-5TP (8 pages)
- DT-601CG (54 pages)
- FGV-XY-Series (32 pages)
- FGE-X (8 pages)
- FGE-HX (8 pages)
- FG-3000 (8 pages)
- FG-7000-Series (8 pages)
- DFS-series (20 pages)
- DRI-series (20 pages)
- EM-series (2 pages)
- FGE-series (4 pages)
- FGV-series (4 pages)
- FGE-H-series (4 pages)
- FGV-H-series (4 pages)
- MF Series (2 pages)
- MFD_Series (2 pages)
- FGS-100E (20 pages)
- FGS-100-PXL (7 pages)