Revo REHVDPTZ22-1 INSTRUCTION MANUAL - Manual (Page 22)

3.8 Pattern (Shortcut: PTRN)
The Pattern feature records user control of the selected dome camera. Up to 4 Patterns can be
stored and played back by pressing No. + PTRN keys subsequently.
PATTERN SETUP
(CTRL KEY)
NO TITLE SEC PERCENT
01 : P01 000 00.0%
02 : P02 000 00.0%
03 : P03 000 00.0%
04 : P04 000 00.0%
TOTAL 000 00.0%
SAVE AND EXIT(ESC TO CANCEL)
Follow steps below to program the Pattern:
1. Press the MENU key to display the main menu on the monitor. Scroll to Pattern and push the
Joystick to the right to enter the Pattern menu. Or just press the PTRN key on the keyboard.
2. Select the desired Pattern to be programmed by pushing the Joystick up or down. If the
Pattern is not 000, a Pattern has already been recorded. Patterns can be overwritten.
3. Press and hold down the CTRL key while controlling the camera direction and zoom with the
Joystick. The dome will be automatically recorded until you release the CTRL key. Or press
the IRIS Open key then the “CTRL” displays. Move the position and the zoom position.
Press the IRIS Close key then the “CTRL” disappears.
4. To edit the “TITLE”, follow the procedure of the Auto Scan above to edit titles.
5. Select “SAVE AND EXIT” and push the Joystick to the right or press the IRIS Open key.
Press the ESC or IRIS Close key to exit the program without saving.
NOTE: Press the HOME key at any programmed position to delete the Pattern.
NOTE: If Pattern recording time reaches 200 seconds, it will automatically stop for a
moment.
Press the PTRN key on the title field to display with the small OSD. Then the screen will show as
below.
PATTERN AREA SETUP
(CTRL KEY)
NUMBER 01
000 00.0%
000 00.0%
EXIT(ESC TO EXIT)
The setting procedure is the same as above.
16