Revo NVR - Manual (Page 67)

Part 4 - Search
67
Event Log Search
Select Search Mode > Event Log Search to bring
up the Event Log Search window.
• Select an event to display the recording made on
the selected time and date (paused state). Select
the Play button in the middle of the screen to start
playing back the recording. Use the drop-down
menu above to load recordings from other cameras.
• You can uncheck the First and Last options at the
top of the Event Log Search window and specify the
search time frame manually.
Select First for From and Last for To to select the
entire recording from start to end.
• If designating From or To settings manually, you will
be able to enable/disable the Check Time Overlap
option.
If the system's clock has been changed and the
designated
From or To point exists at more than
one location, you will have to choose one. Only the
events that took place between the selected
From
and To points will be searched. If Check Time
Overlap has not been selected, events from the
entire
From and To range will be searched.
• Use event filters to include/exclude specific system
events such as Panic Record, Check Recording,
Check Alarm-In, Disk Almost Full, Disk Bad,
Disk Temperature, Disk S.M.A.R.T., Fan Error
and
Disk Config Change from the search.
Camera Filter
• Alarm-In: Select which channels to search alarm-in
events in.
• Motion: Select which channels to search motion
detection events in.
• Video Loss: Select which channels to search video
loss events in.
• Audio Detection: Select which channels to search
audio detection events in.
• Trip Zone: Select which channels to search trip
zone events in.
• Tampering: Select which channels to search
tampering events in.
• Text-In: Select which channels to search text-in
events in.
• Record Channel: Select which record channels to
search events in.
Selected record channels are searched for events
with at least one linked recording. If no camera is
selected, only the events with no linked recording
camera are searched.