Revo NVR User Manual
Page 21
Part 2 - Getting Started
21
3
Select Network Configuration and then click
Next. Select either Auto Configuration or Manual
Configuration and then click
Test to test the
system's current network configuration.
• This test must be performed before
proceeding to the next step.
• If the NVR is on a network connected to a
network that has a DHCP server, selecting
Auto Configuration retrieves LAN settings
such as IP and DNS addresses automatically.
Selecting
Manual Configuration, on the
other hand, lets you specify the settings
manually.
•
UPnP support device not found. If this
error message is displayed, check to see if
the IP router (or NAT) supports UPnP and if
UPnP has been enabled. For more information
about the router's UPnP function, refer to the
router's operation manual.
4
Enter in the
Device Name field the NVR name to
be registered on the DVRNS server and then click
Check to check its availability.
• The device name you register on the DVRNS
server will be a unique name used to identify
the NVR. Once registered, the name can
be used to access the NVR directly from
clients such as the REVO Remote Pro.
Check the name's availability to complete the
registration process. The Finish button will
then become activated.
• You will be prompted with an error message if
you do not enter a name for the NVR or enter
a name already registered on the DVRNS
server.
• Depending on the network environment,
EZLink services may not be active and
therefore prevent the NVR from connecting
to the network. In this case, you will need
to manually configure the ports. For more
information on port configuration, refer to
refer to
5
Click
Finish to exit Network Wizard.