Revo NVR - Manual (Page 55)

Part 3 - Configuration
55
Advanced Setup
Configure security and other advanced camera
settings.
• Video: Adjust the camera image sensor settings
such as white balance and exposure.
• Privacy Masking: Configure privacy masking for
the camera.
• PTZ: If using an RS485-compliant camera,
configure it for use in PTZ Mode.
– PTZ Product: Choose to select the model of
installed PTZ device.
– ID: Choose to assign an ID to each PTZ device.
– Choose to set up Baud Rate, Data Bit, Stop
Bit and Parity of the connected device.
Refer to the PTZ device manufacturer’s instructions
for the proper settings.
Types of configuration options shown vary
depending on the PTZ functions supported by the
camera.
1 2 3 4
5
6
7
8
9
0
Numbers shown below Preset, Scan, Pattern,
and Tour indicate the numbers of configured
functions.
1 Preset
• Use the buttons below to choose a preset
position.
- Directional Buttons ( ):
Used to tilt and pan the camera.
- Zoom ( ): Zoom in and out.
- Focus ( ): Adjust camera focus to far
or near.
- Speed: Specify the camera's panning and
tilting speed.