NSi Industries ELC72 - Manual (Page 4)

2
FEATURES
Daylight saving - Automatic (user selectable)
Leap year - Automatic compensation
Power outage - Super capacitor provides 7 days of
real time back up .
Manual override - Until the next scheduled event
AM/PM or 24 hour format - user selectable
Programming Overview:
The order of the program headers and steps is as
follows:
TIME - set time, date, daylight savings time dates
CONF - 12/24 hour format, stagger up, durations 1-4,
duty cycles 1-4
ASTR - sunrise, sunset, latitude, hemisphere
EVNT - on, off, durations 1-4, duty cycles 1-4
INPT - configure inputs
EVNT SENS - sensor events
HOL - set holidays
In all modes use the NEXT key to advance to the next
item to be programmed or reviewed and the PREVIOUS
key to go back to the previous item . Use the + and -
keys to modify the current (flashing) item .
RUN key to end and PROGAM key to start
The OVERRIDE mode is only accessible from the RUN
mode .
After pressing the PROGRAM key, the ELC71 and
ELC72 will continue to control the outputs based on the
events that were operating at the time the PROGRAM
key was pressed . The control will not check for new
events until it has gone through a status update . The
control remains fully functional after pressing the
REVIEW key, provided the REVIEW key was not pressed
while in the programming mode . During operation, the
control will be in the RUN mode .