KROHNE UFC 500 HART - Manual (Page 48)

HARTô Smart Communications Protocol
UFC500 Command Specification Rev: 2.0 Release Date: 9 Jun 2001
© 2001 KROHNE Mefltechnik D-47058 Duisburg Page 48
Data Byte #6-#9 Transmitter Variable Lower Range Value, IEEE 754, in the RangeUnits. For flowrate
variables is assumed to be zero; hence this variable is ignored by transmitter and sent back as
м0о.
NOTE: For the ReverseFlow the Upper Range Value is stored in EEPROM (if accepted) but will be actually used by the
instrument only when the ReverseScaleControl (refer to Command #156) is set to zero (ìDifferentî) and the function of
any output is set to either ìForward/reverse flowî or to ì2 Dirî (refer to Command #138).
Refer also to comments for Command #35, Write Primary Variable Range Values.
COMMAND-SPECIFIC RESPONSE CODES
0 No Command-Specific Errors
1 Undefined
2 Invalid Selection (of Transmitter Variable)
3-4 Undefined
5 Too Few Data Bytes Received
6 Local Device User
7 In Write Protect Mode
8 Undefined
9 Lower Range Value too High
10 Undefined
11 Upper Range Value too High
12 Upper Range Value too Low
13-27 Undefined
28 Invalid Range Units
29-111 Undefined
112 Pulse Value Exceeded Max and was Corrected
113 Pulse Value Surpassed Min and was Corrected
114 Reverse Range Exceeded Max and was Corrected
115 Reverse Range Surpassed Min and was Corrected
116-127 Undefined