KROHNE UFC 500 HART - Manual (Page 32)

HARTô Smart Communications Protocol
UFC500 Command Specification Rev: 2.0 Release Date: 9 Jun 2001
© 2001 KROHNE Mefltechnik D-47058 Duisburg Page 32
8.16 Command #148 Read User Data
Reads the majority of parameters combined into the User Data submenu (3.5) of the instrument.
REQUEST DATA BYTES
NONE
RESPONSE DATA BYTES
#0 #1 #2
DISPLAY OUTPUTS TOTAL
LANG HOLD RESET
CODE CONTROL
#3 ... #8
VOLUME VOLUME
UNIT UNIT
TEXT TEXT
BYTE #0 BYTE #5
#9 #10 #11
TIME TIME
UNIT UNIT
TEXT TEXT
BYTE #0 BYTE #2
#12 #13 #14 #15
VOLUME VOLUME
UNIT UNIT
FACTOR FACTOR
MSB MSB
#16 #17 #18 #19
TIME TIME
UNIT UNIT
FACTOR FACTOR
MSB LSB
Data Byte #0 Language used for text presentation on the local screen of the instrument:
0 - Gr.Britain/USA,
1 - German.
Data Byte #1 Defines whether the device outputs are frozen during direct instrument control via keypad, or
not:
0 - ìYesî,
1 - ìNoî.
Data Byte #2 Totalizersí reset control:
0 - Reset is disabled,
1 - Reset is enabled.
Data Byte #3-#8 ASCII-text, specifying user-defined volume unit. Say, for US barrels liquid it can be
ìUS_Balî.
Data Byte #9-#11 ASCII-text, specifying user-defined time unit. Say, for minutes it can be ìminî.
Data Byte #12-#15 Scaling factor for user-defined volume unit, relative to cubic meters, IEEE 754. Say, for US
barrels liquid it will be 8.36364.
Data Byte #16-#19 Scaling factor for user-defined time unit, relative to seconds, IEEE 754. Say, for minutes it
will be 60.