KROHNE CORIMASS MFC 85 Interface EN - Manual (Page 33)

33
2 = English
3 = French
0075/0116 Liquid type 1=water
2=non-water RW
Double registers
0083/0131 Mass Total g R
1
. Only available when concentration measurement installed.
2
. Only available when concentration set to referred density
3
. For display format this indicates number of digits after the decimal point and is in the range
0-7. Bit 4 is set if the measurement is enabled.
For display units the byte is divided into a high and low nibble. Each nibble indicates the units
type depending on the measurement as shown in the following table.
1 grams °
C seconds cm
3
2 kilograms °
F minutes dm
3
3 tonnes hours Litres
4 ounces days m
3
5 pounds in
3
6 Specific Gravity ft
3
7 US gallons
8 Gallons
6.6 Error return codes
In the event of a command not being completed, the following error codes may be returned.
1 Function code not allowed
2 Illegal data address
3 Illegal data value
4 Slave device failure
5 Acknowledge - extended time required
6 Slave device busy
7 Failed to carry out request
8 Request to change value refused
9 Custody locked