KROHNE PTD 600 EN - Manual (Page 11)

ELECTRICAL CONNECTIONS
4
11
PTD 600
www.krohne.com 03/2012 - 4001946801 - MA PTD 600 R01 en
Electrical connections
4.1 Safety instructions
4.2 Terminal assignment
DANGER!
All work on the electrical connections may only be carried out with the power disconnected. Take
note of the voltage data on the nameplate!
DANGER!
Observe the national regulations for electrical installations!
WARNING!
Observe without fail the local occupational health and safety regulations. Any work done on the
electrical components of the measuring device may only be carried out by properly trained
specialists.
INFORMATION!
Look at the device nameplate to ensure that the device is delivered according to your order.
Check for the correct supply voltage printed on the nameplate.
Figure 4-1: Terminal assignment for 4-pin M12 plug
1 +V S
(supply voltage)
2 I Out
/GND (current output)
Figure 4-2: Terminal assignment for field housing
1 I
Out
/GND (current output)
2 +V
S
(supply voltage)
3 Shielding
4 Cable diameter: 8...10 mm / 0.3...0.4" (cable not included in delivery)
.book Page 11 Friday, March 23, 2012 10:14 AM