Figure 3. controller to power module interface, Table 1. accessories (continued), Controller to power module interface – KEPCO CA 400 User Manual

Page 8

Text mode
Original mode

CA 400 060700

Adapter is used (for one rack, use either connector J7 or J8). Note that IEEE 1118 requires a
daisy chain configuration only; other configurations (e.g., star) are not supported by Kepco.

FIGURE 3. CONTROLLER TO POWER MODULE INTERFACE

TABLE 1. ACCESSORIES

ITEM

PART NO.

QUANTITY SUPPLIED

Connector Shell

Kepco - 142-0372
(Positronic Industries - MS112N)

Contact, 12 Gauge

Kepco - 107-0327
(Positronic Industries - PLB06M0050)

Cable (BIT bus, 2 meters long, with two 9-
pin DSUB connectors)

Kepco - 118-0844

Terminator, IEEE1118 Control Bus

Kepco - 195-0086

3041592