KEPCO CA 400 - Manual (Page 4)

B 228-1362 COND/CONFORM 052704
Conditions of Conformance
Rack Adapter products (EN61010-1)
When this product is used in applications governed by the requirements of the EEC, the following restric-
tions and conditions apply:
1. For European applications, requiring compliance to the Low Voltage Directive, 73/23/EEC, this Rack
Adapter is considered a component, designed for “built in” applications. Because it is incomplete in
construction, the end product enclosure must provide for compliance to any remaining electrical safety
requirements and act as a fire enclosure. (EN61010-1:2001, Cl. 6, Cl. 7, Cl.8, and Cl. 9)
2. This Rack Adapter is designed for stationary installation, with mains power applied via a detachable
power supply cord or via direct wiring to the source power terminal block.
3. This Rack Adapter, when properly installed, is considered a Class 1 (earthed) product. It is intended for
use as part of equipment meant for test, measurement and laboratory use, and is designed to operate
from single phase, three wire power systems. This equipment must be installed within a suitably
wired equipment rack, utilizing a three wire (grounded) mains connection. See wiring section of this
manual for complete electrical wiring instructions. (EN61010-1:2001, Cl.6.10.1)
4. This power supply has secondary output circuits that are considered hazardous, and which exceed
240 VA at a potential of 2V or more.
5. The output wiring terminals of this power supply has not been evaluated for field wiring and, therefore,
must be properly configured by the end product manufacturer prior to use.
6. For complete circuit protection of the end product, as well as the building wiring, it is required that a pri-
mary circuit protection device be fitted to the branch circuit wiring. (EN61010-1:2001 Cl. 9.5)
7. When installed with other components and/or power supplies, hazardous voltages may be present
within during normal operation. All operator adjustments are made via externally accessible switches,
controls and signal lines as specified within the individual power supply operating instructions. There
are no user or operator serviceable parts within this product enclosure. Refer all servicing to qualified
and trained Kepco service technicians.