KANOMAX 6036 Multi-function thermal anemometer User Manual - Manual (Page 23)

22 Data Output
§ 6 Data Output
Printing Out the Measurement Data (MODEL6036)
To print out the stored measurement
data, an optional printer and printer
cable are required. The printer cable
must be connected to the serial
communication terminal located on the side
of the instrument.
< Requirements >
● Printer (optional)
● Printer Cable (optional)
< Communication Protocol >
You need to enter the same baud rate and data transmission
conditions on both the Main Body and the printer.
 For how to set the baud rate
of the instrument, refer to “Setting
the Measurement Unit and Baud
Rate”. (P.21)
 For settings of the printer, please refer to the operational manual of
the printer.
< Connecting the Printer and the Instrument >
1. Connect the printer and the instrument with the printer cable by
inserting the printer cable in the serial communication terminal
located at the side of the instrument.
2. Turn on the power of the instrument first, and then turn on the
printer.
3. Confirm that the instrument is in the measurement mode.
Printing Directly from the Measurement Mode
Procedure for printing directly from the measurement mode is
described below, taking an example of an operation in the “Air
Velocity/Air Temperature Measurement Mode”.
Hold the reading by pressing the
key.
sign will be displayed in the
upper right part of the LCD screen.
Press the
key to execute printing.
While printing, will be displayed
on the screen.
When printing is complete, the screen
will return to the measurement screen
with the reading held. Measurement
can be resumed by releasing the hold
mode.
Data Bit Length 8 bit
Parity None
Baud Rate Set Value
Stop Bit 1
Serial
Communication
Terminal
■ Print function is
only available
on
MODEL6036