KANOMAX 6036 Multi-function thermal anemometer User Manual - Manual (Page 17)

16 Measurement
§ 3 Measurement
When the instrument is turned on, the LCD test screen will be
displayed for approx. 2 seconds. The test screen will then switch to
the Air Velocity / Air Temperature measurement screen. The display
is updated every 1 second.
Changing the Measurement Mode
To change the measurement mode, press the key while each
measurement screen is displayed. The screen changes as shown
below.
Hold the Reading
While measuring, press the key to
hold the current reading.
mark will be displayed at the 、
upper right of the reading while the
reading is held.
To recover from the hold mode, press
the key again.
By pressing the key while the
reading is held, the displayed reading
will be saved temporarily in the
memory, and hold mode will be
released to resume measurement.
* If the duct dimension is not
set, the screen will switch to the
duct dimension setting screen
Air Velocity/ Temperature
Volumetric flow/
Temperature*
Displayed when volumetric flow
rate exceeds 99,999.
Volumetric Flow rate
= Reading × 100
Air Velocity
Reading
Air
Temperature
Volumetric
Flow
Number of Data Records
Stored
Duct
Shape
* For data
storage, refer
to “Data
Storage and
Statistical
Calculation
Procedure”
(P.18).