Viewing and deleting stored data – KANOMAX 6036 Multi-function thermal anemometer User Manual User Manual

Page 21

Data Storage and Statistical Calculation

Viewing and Deleting Stored Data

The average, maximum and minimum value of the stored data can

be viewed on the display and deleted.
Data viewing and deleting procedure will be described below by

taking an example of an operation in the “Air Velocity / Air

Temperature Measurement Mode”.

●

Viewing the Stored Data

Press the

key when the

instrument is in the measurement
mode in which the data is stored.
The most recently stored average
value (AVG) will be displayed.

●

Viewing Other Data

By pressing the

key, maximum,

minimum and average value of the
data group can viewed. To move to the
previous/next data group, press

keys.

●

Exit from Data Viewing

Press the

key to exit (cancel)

data viewing. When cancelled, the
screen will return to the measurement
mode.

●

Deleting the Stored Data Group

Select the data group to be deleted,

and press the

key. The air

velocity value will start blinking.

To delete the selected data, press the

key again. When pressed,

will be displayed. After displaying

, the screen will return to the

original measurement mode.

To delete ALL data groups stored in the

relevant measurement mode, press
and hold the key for approx. 5
seconds until

is displayed. All

Data Groups stored under this mode
will be cleared. After

displayed, the screen will return to

the measurement mode.

■

The function

of viewing and

deleting

stored data

is available on

MODEL6036

This manual is related to the following products:

6035 Multi-function thermal anemometer